Drawing the human hand takes almost as much knowledge, skill and experience as drawing the entire rest of the figure. However, when drawing the hand, you can adapt many of the same tools and techniques you’re already using to draw the rest of the figure. In this article, I will walk you through a few key ways to approach hand drawing so you can enhance your skillset and create more confident drawings.
Gesture Drawings of the Hand
Gesture drawing is a foundational figure drawing skill. Although you can approach gesture drawings in many ways, most strategies involve doing quick drawings (anywhere from 10 seconds to five minutes) that simplify the subject into as few strokes as possible, as well as favor dynamism over accuracy and large, general forms over small details.
When doing gesture drawings of the full figure, axis lines are used to capture the angle between a pair of landmarks on the body, most often of the hips or shoulders.
In the drawing below you’ll see how you can use a combination of dynamic directional marks and axis lines to capture the angle of the wrist as well as the line of the knuckles. This is an excellent way to quickly capture the most prominent forms and proportions of the hand. Remember, your gesture drawing will lay a light foundation upon which you’ll build the rest of your drawing, so start off as lightly as you can.
Step 1: Whenever possible, begin your gesture drawing with the radius side of the wrist (the side with the thumb). In the drawing on the left, you’ll see a line the moves from the radial side of the wrist all the way up to to the tip of the pointer finger, ignoring the thumb. If the radial side of the wrist and the pointer finger aren’t easily visible, I usually switch to drawing the ulnar side of the wrist to the pinky finger. Pay particular attention to where this line changes direction.
Step 2: You can use axis lines in two different ways while gesturing the hands. The first point is at the wrist. In the middle drawing (fig. 1), you’ll see that I’ve drawn a line from the ulna to the radius. With this angle in place I usually “square up” the wrist, communicating to the viewer the spatial orientation of the box of the wrist.
Next, just as you would use an axis line to capture the angle between pairs of skeletal landmarks of the body, you can draw a single line that captures the position of all four knuckles of the fingers. Ask yourself if the knuckle line appears closer to the tip of the pointer finger or closer to the wrist. I would recommend taking a proportional measurement and comparing the distances while placing the knuckle line.
Step 3: Finally, in the drawing on the right (fig. 1), you’ll see that I’ve gestured each of the fingers and thumb. In this early gestural stage, instead of drawing both sides of the contour of each finger, I usually focus solely on the active side (the outside of the bend) rather than the passive side where the flesh collapses to accommodate the bend. Pay particular attention to where on the knuckle line each finger projects from. You’ll also want to consider the length of each finger in relationship to the rest of the hand, as well as to the other fingers and thumb.
This simple strategy will allow you to capture the most prominent directions, forms and relationships of the hand without getting prematurely mired in details. It’s important to remember: In drawing there are no silver bullets. Drawing the hand is a challenge, and you should expect to make several attempts and revisions. If done with care, this simple technique allows you to capture the basic forms of the hand in proper proportion. This will provide you with a solid foundation upon which you can build the rest of your drawing. before moving forward with more detail.
Here are a few three-minute hand gestures relying heavily on the method just described. Remember, there’s not only one right way to do a gesture drawing, so experiment to find a process that works for you.
The Basic Volumes of the Hand
Another foundational strategy of figure drawing is to simplify the body into its’ most basic volumes. Although there is no single way to do this (and it changes depending on the body of the model, the pose, and the conception of the artist), it is usually a combination of boxes, spheres and cylinders.
When drawing, you should always try and work with the largest forms first and work your way down to smaller forms. The largest volume of the hand is the box-like form that the fingers and thumb connect to. You can think of this box as beginning at the wrist and ending at the knuckle line (once again, ignoring the thumb).
Finding the placement, proportions and spatial orientation of this box is one of the most powerful ways to begin a hand drawing.
The fingers and thumb can be simplified into a series of cylinders with the finger tips being rounded off at the ends. Each finger has three cylindrical segments while the thumb only has two.
In the drawings below I began with the gesture process described above before first drawing the large box of the hand and then drawing the fingers and thumb as a series of cylindrical segments. I’ve paid particularly close attention to the ellipses of each cylinder because ellipses are what show the spatial orientation of the form.
It’s important to note that the box of the hand may change shape, particularly when viewed from the palm side where the bending of the fingers may appear to alter the knuckle line.
Once the size and placement of the various cylindrical segments are drawn you can gesture in any remaining details like the connection of thumb to the box of the hand.
Simplifying the forms of the hand down to their foundational volumes not only helps you orient them effectively in space, but it also helps you understand the overall lighting scheme.
Light interacts with basic volumes in a predictable and logical way. Once you understand the basic volumes of a subject, you understand how light falls over these volumes.
It’s important to remember that as you add details and the light and shadow patterns become more complex, that you keep the overall lighting scheme intact. For example, if you look at the tendons of the fingers, you can see that although they break up the large flat expanse of tieback of the hand, the larger lighting scheme is still dominant.
In the drawing on the left, you’ll see the basic volumes of the hand drawn using the strategies laid out earlier in this article. I’ve also drawn in the basic lighting scheme of these volumes. The large flat plane of the box of the hand is getting a lot of light with the side plane going into shadow and casting a shadow over the volumes of the thumb. Each of the cylinders of the fingers has light on their left side and goes into shadow on the right.
Take some time to compare these two drawings. Hopefully you’ll be able to see that, even though the more finished drawing on the right contains far more detail, that it still retains this overall lighting scheme shown in the drawing on the left.
Keep Learning New Hand Drawing Techniques
Although studying the musculoskeletal anatomy of the hand is essential for successful hand drawing, the techniques you’ve just learned will get you started and ensure that, when you do add anatomical details later on, they’ll be organized with a believable framework.
With numerous ways to approach hand drawing, I encourage you to learn as many as possible. I tell my students that, whenever possible, it’s best to simplify their drawing process and master the foundational skills including gesture drawing, volumetric drawing and light logic. Learning to adapt these familiar strategies to new drawing challenges is an excellent way to streamline your drawing process and distill complex subjects down to accessible and drawable forms.
The post Hand Drawing Made Simple: Key Techniques for Confident Results appeared first on Artist's Network.